DB Driver ¶

The DB driver uses a database to store queue data.

Configuration example:

return [
    'bootstrap' => [
        'queue', // The component registers its own console commands
    ],
    'components' => [
        'db' => [
            'class' => \yii\db\Connection::class, 
            // ...
        ],
        'queue' => [
            'class' => \yii\queue\db\Queue::class,
            'db' => 'db', // DB connection component or its config 
            'tableName' => '{{%queue}}', // Table name
            'channel' => 'default', // Queue channel key
            'mutex' => \yii\mutex\MysqlMutex::class, // Mutex used to sync queries
        ],
    ],
];

You have to add a table to the database. Example schema for MySQL:

CREATE TABLE `queue` (
  `id` int(11) NOT NULL AUTO_INCREMENT,
  `channel` varchar(255) NOT NULL,
  `job` blob NOT NULL,
  `pushed_at` int(11) NOT NULL,
  `ttr` int(11) NOT NULL,
  `delay` int(11) NOT NULL DEFAULT 0,
  `priority` int(11) unsigned NOT NULL DEFAULT 1024,
  `reserved_at` int(11) DEFAULT NULL,
  `attempt` int(11) DEFAULT NULL,
  `done_at` int(11) DEFAULT NULL,
  PRIMARY KEY (`id`),
  KEY `channel` (`channel`),
  KEY `reserved_at` (`reserved_at`),
  KEY `priority` (`priority`)
) ENGINE=InnoDB

Migrations are available from src/drivers/db/migrations.

To add migrations to your application, edit the console config file to configure a namespaced migration:

'controllerMap' => [
    // ...
    'migrate' => [
        'class' => 'yii\console\controllers\MigrateController',
        'migrationPath' => null,
        'migrationNamespaces' => [
            // ...
            'yii\queue\db\migrations',
        ],
    ],
],

Then issue the migrate/up command:

yii migrate/up

Console ¶

Console commands are used to execute and manage queued jobs.

yii queue/listen [timeout]

The listen command launches a daemon which infinitely queries the queue. If there are new tasks they're immediately obtained and executed. The timeout parameter specifies the number of seconds to sleep between querying the queue. This method is most efficient when the command is properly daemonized via supervisor or systemd.

yii queue/run

The run command obtains and executes tasks in a loop until the queue is empty. This works well with cron.

The run and listen commands have options:

• --verbose, -v: print execution statuses to console.
• --isolate: verbose mode of a job execution. If enabled, the execution results of each job will be printed.
• --color: enable highlighting for verbose mode.

yii queue/info

The info command prints out information about the queue status.

yii queue/clear

The clear command clears the queue.

yii queue/remove [id]

The remove command removes a job from the queue.